Life Gleaners｜In the rental house, you can't nail the walls, how do you hang things?

Life Gleaners｜In the rental house, you can't nail the walls, how do you hang things?

I. Introduction:

Good day, my friend, I'm Brother Stone. The holidays are almost over, and I am ready to start looking for a rental house to welcome the start of school in September. Brother Shitou left Valentine's Day to his father who had just been discharged from the hospital. With this carpenter master who has been working for more than 50 years, he could just do woodworking experiments at home: Let's see how to hang bookshelves and accessories without nailing the wall? I think this is quite suitable for you who like to hang decorations, but are afraid of being made difficult by the landlord.

2. Why won't the landlord let me nail the wall?

In fact, with the rapid changes of the times, the floors of the family are getting higher and higher. In the early days, red brick walls and RC walls were used as partition walls, which required long construction time, high cost, and heavy weight on the floor. In this way, there may be no one in the construction industry. I want to operate, so the mainstream of modern cubicles has moved to light cubicle construction.

Pleasant sound: light compartment; real: "Styrofoam ball" and "sound insulation cotton" are stuffed empty inside the wall

Dry construction cubicle: For the general indoor room, a dry construction cubicle is adopted. The pictures in the partition wall, such as stone brother, show that it is a piece of gypsum board + sound insulation cotton +..., the fastest construction speed and the lightest weight , it is also the easiest to disassemble when the pattern is to be changed.

Wet construction compartment: For bathrooms, kitchens and other water-using areas, adopt wet construction compartments, and fill the compartments with lightweight concrete + styrofoam balls +..., the lighter the wall weight, but the concrete still remains. Water permeable properties.

After reading it, are you surprised? Brother Stone was dumbfounded when he saw it. It turns out that the walls of my house look like this...
After verification, it is true that most of these partition walls are constructed in accordance with the fire prevention time limit, sound insulation effect, etc. stipulated by the building regulations.

3. How can I hang things without nailing the wall?

Case exercise:

1. Draw a PPT design composition:

I wanted to hang seven Nordic-style pine shelves on the wall. After the composition design, I decided to echo the titanium mirror on the left hand side, so the design composition made the shelves a little undulating.

2. You have four hanging options (as shown in the picture):

2-1. Steel nails: For the brick walls of general old buildings, frankly speaking, I will use steel nails (far right in Figure 1) to directly hit the wall, and then use connecting pieces or triangular buckles (10 pieces for 28 yuan).

2-2. Sawtooth hanging piece + Autobot wall nail: This is the most commonly used hardware accessories for general storage frames on the market (12 pieces of 50 yuan). Basically, I think it is quite practical.

2-3. Nail-free and traceless screw stickers : This is the hanging artifact that Shitou found in unlimited searches this time. No-ding hanging non-marking screw stickers (1 piece 5 yuan), the screw lengths are 6mm, 8mm, 10mm..., The key point is "no nail marks + bearing 5kg " (known as).

2-4. Super strong nail-free 3M double-sided tape: I bought it when I first wanted to hang it, because it said that it could bear 140g per centimeter, which made me think for a long time whether it can bear the weight of the storage frame? Do I need to weigh in beforehand? How long should I cut...? There are too many problems, I finally gave up after finding the hardware of 2-3.

3. Tips learned from failure:

Since there are three storage frames on the design drawing that are close to each other, after pasting the "Nail-Free Non-marking Screw Stickers" one by one, two separations occurred and could not be closely attached, which was super dumbfounded... So I had to fail a "Nail-Free Screw Sticker". Tear off the seamless screw sticker and change it to:

3-1. First connect the three storage frames with connecting pieces;

3-2. Then, lock the triangular hooks on the three storage frames respectively;

3-3. Next, use a ballpoint pen to mark the desired height on the wall, and finally glue the "Nail-free and seamless screw sticker", and you are finally done.

3. Conclusion:

In order to hang these seven Nordic-style pine wood racks, Brother Stone bought L-shaped iron angles, steel nails, nail-free glue, nail-free non-marking tape... until Google searched for nail-free and non-marking Screw stickers, only to know that this thing can be used now, it is really convenient. In the rental house, you can't nail the wall, how do you hang things? Welcome to the message area below to share the useful hardware accessories you found, so that everyone can use it easily.